Reply to thread

Message

The most obvoius damage occured by mistreatment, but what I'm also noticing, is that there are telltale signs of major air pockets between the surface layer, and the fiberglass layer. The chips are broken away cleanly, and the fiberglass layer left behind is smooth in areas. If it were a nice tight, clean lamination, the only damage you would see, is the actual cracks.

My advice: If you want a mystry helmet, send a pm to M_S, and don't mess with the ebay recasters.

[QUOTE="judz dwedd, post: 47994, member: 76"] The most obvoius damage occured by mistreatment, but what I'm also noticing, is that there are telltale signs of major air pockets between the surface layer, and the fiberglass layer. The chips are broken away cleanly, and the fiberglass layer left behind is smooth in areas. If it were a nice tight, clean lamination, the only damage you would see, is the actual cracks. My advice: If you want a mystry helmet, send a pm to M_S, and don't mess with the ebay recasters. [/QUOTE]

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification