Reply to thread

Weren't some of the RFs on the 95's solid resin? This may be the case. The others were injection molded (and hollow). There is a very clear seam that goes all the was around the top of the RF. This should pop open easily if it is a hollow one that you have.

Art


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top