Reply to thread

Also as an update for any forum lurkers... my Bobamaker jetpack actually has the part that touches your back (part that you put the metal clips/hooks on) as ABS plastic so drilling it should be relatively straightforward since plastic is way easier to deal with than fiberglass.


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top