Reply to thread

If you're wanting as clean a job as possible, you'll want to go as slow as possible while using the sharpest drill bit you can get your hands on. Cobalt drill or the like would be ideal. Just make sure you take the lightest chip ya can and you shouldn't see any cracking. After that I'd lightly countersink the tops of the holes so as to reduce the chance of cracking in the future


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top