How to dent the helmet?

Hordofmine

New Hunter
Hello everyone, I am a first time costume builder and have a couple questions. I want to build a Boba Fett helmet out of Eva foam. Any tips for working with foam would be awesome. But how do you make the dent? Are any layers added on the inside to get the depth?
 
I think doing it out out of Eva foam would be far more tricky, than for instance using thin wetted cardboard cut to fit with grooves to make it fit well. I went that approach and used bondo on it for my first scratch build, and it went well for what it is. For a screen accurate dent I recommend 3D printed versions to insert.


Sent from my iPhone
 
This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top