Reply to thread

Heat the back of the armor (the side facing in) with a heatgun and then use a screwdriver (pointy for scratches / handle for dents) to make the impressions.


The cod piece should have two layers.  One large shape for the entire cod and then a teard drop shape top center.  Crazy glue is an excellent adhesive for laminating the 2 pcs together.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top