Reply to thread

I might be getting a helmet cheap from a buddy that needs lots of work.  It looks like there are lots of small air bubbles in it and other imperfections.  If I get it I would make sure all the lines are smooth but, what about items like the dome?  It almost looks like there is physical weathering.


So, do I smooth it out or let it go so that it adds to the character of the helmet?


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top