Reply to thread

Message

Im going to be getting some MB Gauntlets soon and I think this is how I'm gonna do it. I figure that with the outer pieces on there over the seem, the flame thrower and hose attachment, that I dont want to be bending them too much, so I'm going to permanently attach the outter edges and on the opposite sides Im going to glue a large piece of elastic so they hold together tight, but also spearate slightly so I can slide into them. Just an idea.

[QUOTE="Kylash327, post: 916"] Im going to be getting some MB Gauntlets soon and I think this is how I'm gonna do it. I figure that with the outer pieces on there over the seem, the flame thrower and hose attachment, that I dont want to be bending them too much, so I'm going to permanently attach the outter edges and on the opposite sides Im going to glue a large piece of elastic so they hold together tight, but also spearate slightly so I can slide into them. Just an idea. [/QUOTE]

This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification