Reply to thread

I just got mine too.I am going to use a CA glue for the outer seam,and then use a swatch of ABS on the inside of the seam,and epoxy it all along the seam for a permanent bond.I am going to do the original method of using velcro on the inner part of the clamshell.I would paint them after they are completely assembled.


Steve


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top