Reply to thread

It might also be that you don't have enough fabric in between the two halves of the female side - especially if you're using the heavy-duty snaps.  If you don't the centre piece sticks up too far and it won't snap into the male side.  Learned that one the hard way.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top