Reply to thread

Message

I used Humbrol paints for all of my surface work on my build except for the silver layer.The reason I
went with Non-Buff Aluminum was that most of the silver paints that I tested (and I tested a lot) did not
hold up and lost their reflective quality when sealer went over them. My best result was with Model Master
Non -Buffing Sealer over Non- Buff Aluminum. In fact I ended up using that sealer over my entire paint job
and it worked exceptionally well ,even with multiple coats. More on the first page of my thread-The Builders ESB Build.
Hope this helps, have fun painting,I think it's the best part.

[QUOTE="Builder, post: 500767, member: 9056"] I used Humbrol paints for all of my surface work on my build except for the silver layer.The reason I went with Non-Buff Aluminum was that most of the silver paints that I tested (and I tested a lot) did not hold up and lost their reflective quality when sealer went over them. My best result was with Model Master Non -Buffing Sealer over Non- Buff Aluminum. In fact I ended up using that sealer over my entire paint job and it worked exceptionally well ,even with multiple coats. More on the first page of my thread-The Builders ESB Build. Hope this helps, have fun painting,I think it's the best part. [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification