Help mounting Knee darts


So I have a set of machine craft knee darts for my rotj knee pads. I've mounted them by drilling holes in the knees and using machined flathead screws on the other end. The only problem is they aren't sitting flush because the outside edge of the knee pad is slanted. Do I just dremel out the whole backing? I'm not sure how to proceed...plz help!


  • 20190629_192434.jpg
    2.5 MB · Views: 370
This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.