Reply to thread

I'm wanting to make a mando helmet, but I don't know what would be the easiest route. This is not for the 501st, but my custom character. I'm trying to make a mandalorian jedi and want to get as much as I can for as little as possible.

 

The helmet needs to look decent up close, but not perfect. I'm not putting the RF on it, it'd get in the way of the hood. I have a piece of plastic that I found in the trash, I'll try to use that for the armor. I'll try to batting helmet/bucket mix for the helm, but ned to know how it's done, and what parts go where.

I also need to make a lightsaber and a blaster. It just seems right to add a gun, for some reason.

 

Any/all help is appreciated, HF


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top