Reply to thread

Definitely cut the entire visor area out.  If you can get it out in one piece, use that as a template and add 1/4" all around for mounting.  Don't leave any of the old visor or black vinyl area in the helmet.


"Wipe them out; all of them!!!!" muahahahahahahah


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top