Reply to thread

I am new to this and am starting with a rubies Jango Fett helmet. The visor in it sucks and I want to cut it out and replace it. I have seen people mention getting a welders shield and cut it to fit. I am afraid I will cut it to the wrong size since I do not have a template. What would be the best way to replace this visor? Should it be flush with the inside of the helmet of fit exactly in the space that is cut?

Thanks for your help!


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top