Reply to thread

Message

I don't know if this will help, but I made a template for the 14 ESB kill marks for my helmet. I did some research on the reference cd and I believe the stripe proportions and weathering marks are correct.

I printed them out, cut out the black parts with an exacto knife, cut on dotted lines and taped to the helmet. I believe the bottom of the stripes should be 1/4" above the red brow.

(The second row of stripes are for optional use.)

Here's the template and a photo. I'll post the result tomorrow. Hope this helps someone!
- Chris

[ATTACH=full]78255[/ATTACH]

[ATTACH=full]78256[/ATTACH]

[QUOTE="Trooper TK409, post: 13949, member: 254"] I don't know if this will help, but I made a template for the 14 ESB kill marks for my helmet. I did some research on the reference cd and I believe the stripe proportions and weathering marks are correct. I printed them out, cut out the black parts with an exacto knife, cut on dotted lines and taped to the helmet. I believe the bottom of the stripes should be 1/4" above the red brow. (The second row of stripes are for optional use.) Here's the template and a photo. I'll post the result tomorrow. Hope this helps someone! - Chris [ATTACH=full]78255[/ATTACH] [ATTACH=full]78256[/ATTACH] [/QUOTE]

This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification