Reply to thread

Welcome aboard.

I'd also put a conservative price of $1500.

 but then again, it helps to know people.

Your best bet (if you'd like to do this cost-effectively) is to make your own parts, then sell them to others.

 this gets your name out there, cuts costs & makes you new friends.

Just make sure that what you make is high quality.



Nice Z by the way.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top