Reply to thread

Heat gun works wonders.. I mean you put it over the plastic.. it makes it flimsy in seconds... and it doesn't take much to do a big piece of plastic.. as it stays frigin' hot for about a minute as you go along and do the rest of the piece... I think the guns are pretty cheap.


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top