Reply to thread

All,

I got the little plastic piece made and installed. I'll probably hit the components with a flat clear enamel to protect it a bit. but what are your guys' thoughts?

[ATTACH=full]189678[/ATTACH]


To create and install that plastic piece I used these items...

[ATTACH=full]189679[/ATTACH]


and for paints I used....

[ATTACH=full]189680[/ATTACH]


Even though this is a US Army Half Shelter, would you guys worry about toning down the Olive Drab (Fade)? I also may take it back to the seamstress who did the seams for me and have her use a beige/tan thread for that thicker seam. But then again I'm not looking at getting 501st Cert'd either. But I may wanna do that prior ripping it up and weathering it. I'll have to think on that.


Thanks,

-Iron


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top