Reply to thread

Message

[USER=8494]ShortFuse[/USER] - $10.00 eh? Nice, now I feel like I overpaid! hahaha! And yep, I seen that .pdf too, a great tutorial for sure! A couple points that could use revision on in my opinion.
1) Doesn't make mention of the two other Grommets like the 501st pic - for that piece of plastic. (Only for Level II Cert)
2) The picture show a bit too much damage (holes) in it.
Other than that I thought it was a great tutorial.

[ATTACH=full]188513[/ATTACH]

Also, has anyone used a lighter to achieve the burn and scoring marks as opposed to black paint (air brushing)? A bit more risky for sure.

Thanks,
-Iron

[QUOTE="Irongladiator, post: 493044, member: 13129"] [USER=8494]ShortFuse[/USER] - $10.00 eh? Nice, now I feel like I overpaid! hahaha! And yep, I seen that .pdf too, a great tutorial for sure! A couple points that could use revision on in my opinion. 1) Doesn't make mention of the two other Grommets like the 501st pic - for that piece of plastic. ([I]Only for Level II Cert[/I]) 2) The picture show a bit too much damage ([I]holes[/I]) in it. Other than that I thought it was a great tutorial. [ATTACH type="full" alt="Fett Cape.jpg"]188513[/ATTACH] Also, has anyone used a lighter to achieve the burn and scoring marks as opposed to black paint ([I]air brushing[/I])? A bit more risky for sure. Thanks, -Iron [/QUOTE]

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification