Reply to thread

[USER=7869]Boochman[/USER] - Maybe I'm still confused about how it all hooks up then. When I look at the 501st reference pic I can see the two grommets (I labeled them as #1 and #2 - for ease of reference). The #1 Edge Grommets (Closest to the edge of the cape) is hooked up to the Collar/Back armor via the square stud. So......that would mean that #2 Grommet has the other has the blot/nut on it to hold in that plastic piece. And the #1 Edge Grommet is not only secured to the Collar/Back armor but also the plastic piece too - yes?


[ATTACH=full]188297[/ATTACH]


Forgive me [USER=11773]roger12RAMJET[/USER] for stealing your photo, but I'm just looking for clarification on this. Please see your photo I doctored up to see if I'm understanding it correctly.

[ATTACH=full]188298[/ATTACH]


Thanks for educating this noob! ;)


Thanks,

-Iron


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top