Reply to thread

I had a similar problem w/ my bucket after masking w/ liquid mask & then painting.  I was in such a rush that I did not allow for the mask to completely cure & after I sprayed my green on, it knda ate little lines through the mask.  Also, I had to leave my silver cure for at least a couple of days, otherwise some of the mask pulled off bits of silver paint right down to the primer.  I think the dent looks pretty cool on yours though!  I guess I'd leave it, but thats just me :)


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top