Reply to thread

So if I wanted to use an adhesive for construction of my jet pack which is going to be made mostly from sintra, would plumbers goop be the way to go. There are a lot of corners and edges in the design of the Jet Pack, and I want it to be sturdy. I'm a little weary of the fact that it has some give to it. Is there something better suited for this particular application?


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top