Reply to thread

Message

So here is the pattern we used for the back of my gloves. Again these measurements are for my hand but it will give you an idea. This allowed for 1/4 inch seam allowance once the pads were sewn together. We added quilt-light batting between two layers of the tackle twill for the pads on the back of my hands and fingers. It gave it a more quilted look.
[ATTACH=full]169674[/ATTACH]
For my fingers we just measured from the tip of the finger to just above my knuckle. Again with the gloves on and then tried to make them all appear even.
Hope this helps.

[QUOTE="John Spendow, post: 476152, member: 11778"] So here is the pattern we used for the back of my gloves. Again these measurements are for my hand but it will give you an idea. This allowed for 1/4 inch seam allowance once the pads were sewn together. We added quilt-light batting between two layers of the tackle twill for the pads on the back of my hands and fingers. It gave it a more quilted look. [ATTACH=full]169674[/ATTACH] For my fingers we just measured from the tip of the finger to just above my knuckle. Again with the gloves on and then tried to make them all appear even. Hope this helps. [/QUOTE]

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification