Reply to thread

The calc pad area is too long.


Make the area where the clamshell attaches to top strait (right angled), not curving into the top. 


I'd also make the missle a separate part and not part of the mold. 


A dental expander goes where you put the red light.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top