Reply to thread

Sleezy, the dowel rod I used was 3/8" in diameter, and about 3.5 inches long.  One end of the dowel rod must be whittled or sanded (about an inch) so that it will fit into the 3/8" brass tube along the bottom of the resin side piece.


Hope that helps!


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top