Reply to thread

Yea I found the air compression coupling also after I did my first prototype...I did my first one using those sized parts...the next two versions I did  I used a 3/8 and 5/16 flair nut....for the coupling I had to buy the all tube unions with inserts 5/8 and 1/2 inch...I had to file off the threads on each side of the center nut...and then used a 3/8 and an 1/8 inch brass nipple....so these parts make the next two bigger sized fittings .  The sizes that michealmax used are the same ones I used to make the first one that Braks has now. After seing seekers pic of his gauntlets and his fittings I think maybey the smaller ones are correct Art. But maybey the gauntlet is not correct in size proportion as well? Well at least Art will have all three version to compare for us when he makes his trip.


Jimmy


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top