Reply to thread

Message

sorry Mojo, don't see this before....today I' ll continue with this...
do you or Alan have the templates of the lower clams shells, and there is some update with the main blueprints?
I'm having some problems with the PVC thickness, cause it's very dificult to adapt it (need a thin pvc for the small parts)...
I think that maybe the best way to work them in PVC would be to first make the big parts ( upper and lower clams shells) and then make in other pvc the small parts....
any help will be aprecited....
thnx so much!

[QUOTE="chewiepal, post: 61384, member: 827"] sorry Mojo, don't see this before....today I' ll continue with this... do you or Alan have the templates of the lower clams shells, and there is some update with the main blueprints? I'm having some problems with the PVC thickness, cause it's very dificult to adapt it (need a thin pvc for the small parts)... I think that maybe the best way to work them in PVC would be to first make the big parts ( upper and lower clams shells) and then make in other pvc the small parts.... any help will be aprecited.... thnx so much! [/QUOTE]

This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification