Reply to thread

First posting here so please bear with me! Recently obtained a set of ESB gauntlets from Ruffkintoys (great set by the way, highly recommended) and need some advice about assembling and spraying them. So here goes:


1/ What is the best method for filling in the occasional gap/air bubble in resin castings?


2/ What color green should I use when spraying them (I intend to use automotive spray cans, UK colors would be very helpful)?


3/Can anyone provide me with some decent views of the screen used gauntlets for weathering reference?


Any other advice people think relevant would be great.


This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top