Reply to thread

I tend to stay away from stuff that sounds like "epoxy" cause of the health damages...hehehe. Actually, I just do the rubber mold/resin casting which is a lot more time consuming, but that way, the sculpey can be sanded down without problem after it's baked and i have a problem with the original. Do you find that it's worth it to get stuff that smooth? I mean, eventually mostly everything gets weathered anyway...But I can definately see your point. And 6 lbs really is a good amount of gapoxio. sculpey is more expensive it seems.


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top