Reply to thread

MarrowSun,

 

I know this thread has not been active for a while, but I have a few questions about how you shaped/sclupted the pieces

 

1. did you carve them out of foam rubber from the start, or use something else to get the detail.

 

2. what tools did you use to sculpt with kinfes, dremel bits?

 

any help would be appreciated.


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top