Reply to thread

I have the BM VX.  None of JC27s kit will work with the current BM setup.  For the kits using the Honeywell Microswitch you need a hollow stalk. 


For the self contained kits, there’s not enough space as the Perspex/resin block is taking up almost the whole space.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top