Reply to thread

Message

Servo shaft extension test fitting.

Drilled stalk and helmet with a 3/8" bit to fit shaft. drilled 17/64" hole for grub screw, taped hole with #6 tap. Worked like a charm.
[ATTACH=full]157938[/ATTACH]
[ATTACH=full]157939[/ATTACH]
[ATTACH=full]157940[/ATTACH]
Test servo fit.
[ATTACH=full]157941[/ATTACH]
Nothing here is permanently done and only test fit to see how it works, but it once I get to know how the servo is set and how much to cut off the servo shaft it will be done.
Lynn

[QUOTE="Lynn TXP 0369, post: 460343, member: 21"] Servo shaft extension test fitting. Drilled stalk and helmet with a 3/8" bit to fit shaft. drilled 17/64" hole for grub screw, taped hole with #6 tap. Worked like a charm. [ATTACH=full]157938[/ATTACH] [ATTACH=full]157939[/ATTACH] [ATTACH=full]157940[/ATTACH] Test servo fit. [ATTACH=full]157941[/ATTACH] Nothing here is permanently done and only test fit to see how it works, but it once I get to know how the servo is set and how much to cut off the servo shaft it will be done. Lynn [/QUOTE]

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification