Reply to thread

A little more done today.

Visor Chicago screw bolts epoxied in place. I won't bolt the visor in place until I let the epoxie sit for 24 hours.

[ATTACH=full]157605[/ATTACH]


Ear holes marked and drilled.

[ATTACH=full]157606[/ATTACH]

[ATTACH=full]157607[/ATTACH]


Helmet ear holes drilled. For some reason I had a heck of a time drilling the right ear cap top locations.

[ATTACH=full]157608[/ATTACH]

[ATTACH=full]157609[/ATTACH]


Ear cap installed. I put too long a screw in the ear top and I dimpled the ear out a bit, I'll have to sand that flat.

[ATTACH=full]157610[/ATTACH]

[ATTACH=full]157611[/ATTACH]

[ATTACH=full]157612[/ATTACH]

Lynn


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top