Reply to thread

Message

<blockquote data-quote="Fettism" data-source="post: 48198" data-attributes="member: 668">Look what I found . As far as I can tell ( again I'm no expert ) from the pics on the other thread this set up is pretty close . With some primer and aluminum paint and some fine misting with black or rust for weathering they should look close . These are 1'4&quot; . I have a 1/4&quot; threaded rod to run through the center which the hose will be slipped onto .I'll thread the back end into the gaunt and secure with a lock nut . A question for the pros .......... what does the second fitting ( the lower one on the right gaunt just under the seam where the 2 halves meet ) go into . On the pics I've seen it looks like a tube or dowel ??? I have a Ruffkins set up and 2 other sets of gauntlets and niether have this tube . What is it and what do i use to make it ? I would like to attach these connectors soon .Mike&nbsp;&nbsp; [ATTACH=full]650[/ATTACH][ATTACH=full]651[/ATTACH]</blockquote>

[QUOTE="Fettism, post: 48198, member: 668"] Look what I found . As far as I can tell ( again I'm no expert ) from the pics on the other thread this set up is pretty close . With some primer and aluminum paint and some fine misting with black or rust for weathering they should look close . These are 1'4" . I have a 1/4" threaded rod to run through the center which the hose will be slipped onto .I'll thread the back end into the gaunt and secure with a lock nut . A question for the pros .......... what does the second fitting ( the lower one on the right gaunt just under the seam where the 2 halves meet ) go into . On the pics I've seen it looks like a tube or dowel ??? I have a Ruffkins set up and 2 other sets of gauntlets and niether have this tube . What is it and what do i use to make it ? I would like to attach these connectors soon . Mike [ATTACH=full]650[/ATTACH] [ATTACH=full]651[/ATTACH] [/QUOTE]

Verification