Reply to thread

I'm curious as to what each of these would be used for.  Latex is usually thinner right, its what is commonly used in masks and prostethics (sp?) correct?


So, I guess really the difference between foam and foam rubber.  I'd think what I want to used for modeling with is foam rubber, I need something somewhat stiff  that can be cut/carved.  Almost like the texture of those wedge sponges that come with halloween make-up.


If anyone  knows of an online supplier for this stuff as well I'm going to need a few chunks of the stuff.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top