Reply to thread

Yup, my bucket is almost finished.

BUT I don't want to screw it up now by making a mess of fitting the spangly new T-Visor.


So, WHat's the best way to do it?

Build up the area around were it's going to make contact with the helmet to give more surface area for the glue to take hold with, or just glue it straight in place as is?


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top