Forums
New posts
Search forums
Non-stemming search
Media
New media
New comments
Search media
Members
Registered members
Member Map
Current visitors
New profile posts
Search profile posts
Our Communities
The Replica Prop Forum
The 405th Infantry Division
Ladies of the Legions
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Non-stemming search
Menu
Log in
Register
Install the app
Install
Forums
Star Wars Bounty Hunters • Original Trilogy
Boba Fett Costume
Finished my Pulce this morning
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="bobafettaz" data-source="post: 505356" data-attributes="member: 13964"><p>I bought a 3D printed kit on eBay and just finished the build this morning. I used CA+ and Zip Kicker to connect it all plus some JB Weld around the edges of the connecting pieces for some extra strength and to fill in the minor gaps where they didn't sit flush. I just need to spray it with a clear coat. </p><p></p><p>I opted to keep the cross bar because I didn't want to tackle smoothing that out on a 3D print. I think cutting it off an actual Pulce would be a lot easier. I debated painting the front all silver but ultimately decided on the orange/brown color at the front since I was keeping the crossbar and also that's how it looks in the current CRL. For the orange/brown color, I bought Humbrol 100 on eBay and mixed in a little Humbrol 33 to darken it a skosh. </p><p></p><p>I'm waiting on my armor and holster from Boba Maker and look forward to putting this baby into the holster.</p></blockquote><p></p>
[QUOTE="bobafettaz, post: 505356, member: 13964"] I bought a 3D printed kit on eBay and just finished the build this morning. I used CA+ and Zip Kicker to connect it all plus some JB Weld around the edges of the connecting pieces for some extra strength and to fill in the minor gaps where they didn't sit flush. I just need to spray it with a clear coat. I opted to keep the cross bar because I didn't want to tackle smoothing that out on a 3D print. I think cutting it off an actual Pulce would be a lot easier. I debated painting the front all silver but ultimately decided on the orange/brown color at the front since I was keeping the crossbar and also that's how it looks in the current CRL. For the orange/brown color, I bought Humbrol 100 on eBay and mixed in a little Humbrol 33 to darken it a skosh. I'm waiting on my armor and holster from Boba Maker and look forward to putting this baby into the holster. [/QUOTE]
Insert quotes…
Verification
Post reply
Forums
Star Wars Bounty Hunters • Original Trilogy
Boba Fett Costume
Finished my Pulce this morning
Top