Reply to thread

You could try painting on layers of FG resin & then sand those until smooth which would be time consuming, add weight & cost OR use a skim coat of bondo which will also add weight.  I can't think of any other way to fix this.


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top