Fettronics/Jupiter Electronics thickness?

56Strat

New Hunter
Hello fellow Fett enthusiasts, I'm undertaking a little project to paint my PS5 faceplates. I will be doing 1 plate the layered armor green and the other plate the layered shoulder yellow and thought it may be cool to try and install a Fettronics or Jupiter Electronics on the armor side. There isn't a huge amount of space to play with between the plate and the actual system. How thick are they? I figure that hot glue will be best for install should I go through with it, but first need to figure out thickness, length, and width to be able to determine if there is space on either side of the console. Any help would be greatly appreciated!
 
This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top