Reply to thread

Nice work! I've been trying to find an accurate MPP but will probably have to have a tube made. What are the distances between the hole groupings? I seem to recall that they are not laid out as simply as NSWE positions on the accurate tube.


This thread is more than 6 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top