Reply to thread

Glue the magnets on the back of the armor with 2 part 2 minute epoxy.


Line up the armor where you want it and put the magnets on the back of the vest,- the armor will temporarialy stay for you to tape the magnets to the backside of the vest- then duct tape the magnets in the back in place with all the armor attached on the front. Take the armor off and with the magnets still in place on the back, take more magnets and attach them exactly where the magnets are from the back, and put them on the front where the magnets where on the armor that you glued on the inside. apply patches and glue with 2 minute epoxy.


Then your done, simply let the armor magnetize to the vest.



Glue the magnets on the front of the vest with fabric patches.


how strong is it, the last picture, the whole entire vest, I am picking it up by the diamond which has 2 magnets in it only.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top