Reply to thread

for cutting the armor out of the cans... first i used a skil-saw to trim them to a very rough cut out and something smaller to work with. from there it was a ruler and utility knife. i made a few cuts along each edge then snapped them off individually. like jimmy buffett said, take your time and don't rush! and thanks for the positive comments, it really means a lot coming from everyone on tdh.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top