Reply to thread

i'm on my way with my first set of armor. i've got all i could cut out of the trash cans last night. i'm going to attempt the cod piece since i had some space left on the smaller can. ran out of space for the back piece which probably wouldn't work well out of a trash can anyway. next step will be cleaning up the edges, denting and sanding for primer.


[ATTACH=full]5697[/ATTACH]


[ATTACH=full]5698[/ATTACH]


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top