Reply to thread

Message

thank you

I used a piece of plexiglas and bened that, the entire inside of the "chamber"is almost entirly kitted (bondo that glues) so that's pretty rigid... it's the point at the handle that goes into the chamber just at the edge of the wooden grip where it broke.

got like thousands of tips on how to fix it, with kit, glue, bondo etc.. but it's never going to last very long, so I may fix it someday with some aluminium plates on both sides and screw them together, but even that it will be for display only I gues..

[QUOTE="RBF, post: 55569, member: 604"] thank you :) I used a piece of plexiglas and bened that, the entire inside of the "chamber"is almost entirly kitted (bondo that glues) so that's pretty rigid... it's the point at the handle that goes into the chamber just at the edge of the wooden grip where it broke. got like thousands of tips on how to fix it, with kit, glue, bondo etc.. but it's never going to last very long, so I may fix it someday with some aluminium plates on both sides and screw them together, but even that it will be for display only I gues.. [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification