Reply to thread

Message

Wow...the timing on this is fortuitous. I need a blaster, was thinking of building one of these, then, voila. The resident genius posts schematics.

Not to sound like too much of a nooB idio, but what were people planning to make these from?

I'm sorta thinking of cutting the grip/body portion out of wood, using some pvc for the barrel housing/upper receiver, then metal rod for inner barrel. But that might not be the best way. Can't wait to see what people come up with.

[QUOTE="precentorjames, post: 157447, member: 2374"] Wow...the timing on this is fortuitous. I need a blaster, was thinking of building one of these, then, voila. The resident genius posts schematics. Not to sound like too much of a nooB idio, but what were people planning to make these from? I'm sorta thinking of cutting the grip/body portion out of wood, using some pvc for the barrel housing/upper receiver, then metal rod for inner barrel. But that might not be the best way. Can't wait to see what people come up with. [/QUOTE]

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification