Reply to thread

Message

Hello,

I haven't on in a while but I wanted to give you a peek at what I have coming down the pike. I was going towait untill I had a proto type built, but I have bee swamped with other issues, so I figured that I better post these sooner rather than later.

These are only a draft, but they are pretty close. The barrel drawing is based off of Bradlyfett's which he has given me permission to use. I have designed the barrel to made from Al tubing so that there is no machining needed just a hacksaw and a file.

Take a look and let me know what you think.

Alan

[ATTACH=full]88893[/ATTACH]

[QUOTE="wizardofflight, post: 157439, member: 576"] Hello, I haven't on in a while but I wanted to give you a peek at what I have coming down the pike. I was going towait untill I had a proto type built, but I have bee swamped with other issues, so I figured that I better post these sooner rather than later. These are only a draft, but they are pretty close. The barrel drawing is based off of Bradlyfett's which he has given me permission to use. I have designed the barrel to made from Al tubing so that there is no machining needed just a hacksaw and a file. Take a look and let me know what you think. Alan [ATTACH=full]88893[/ATTACH] [/QUOTE]

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification