Reply to thread

Message

Maybe this has been posted before, but I was thinking about printing all the stencils on clear decal paper. That way one would just have to cut it out roughly around the outlines, stick it on the helmet and paint. Kinda like a paint by numbers (at least I think it's called that way? ).
Could be a lot easier than cutting everything out with an x-acto knife I think..
What do you guys think? Good idea? Or has this been done before? (In that case sorry for repeating)

[QUOTE="Lord Vicious, post: 101065, member: 1663"] Maybe this has been posted before, but I was thinking about printing all the stencils on clear decal paper. That way one would just have to cut it out roughly around the outlines, stick it on the helmet and paint. Kinda like a paint by numbers (at least I think it's called that way?:) ). Could be a lot easier than cutting everything out with an x-acto knife I think.. What do you guys think? Good idea? Or has this been done before? (In that case sorry for repeating) [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification