Reply to thread

Now i do the red stripe on the lower right. I do this with the Humbrol #100  The stripes from what i can see look to be rough on the edge towards the center of the pack so i do that by just dabbing with a small brush on that edge and just cleanly shaping the rest of them.[ATTACH=full]159645[/ATTACH] [ATTACH=full]159646[/ATTACH]


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top