Reply to thread

The Rf earcap was remade with a more proportional triangle shaped bottom, hard to tell from the pic I used.  Also I have used a three piece earcap design that is bolted to the helmet.  The outer earcap section uses countersunk magnets for accessability.  The left side earcap has been reshaped and lengthend.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top